Give-way-line

This function is used for designing give-way-lines.

The following sequence of questions will appear at startup:

Setup/<Enter point or press ENTER to select>: (P1) 

By choosing "Setup" the Road Marking setup dialogue is accessed, allowing the user to make changes to the give-way-line parameters. The method used for give- way- line design is dependent of what action the user chooses. One can pick a point in the drawing (P1) and activate the three point procedure, or one can press ENTER and pick a pre-designed polyline which the give-way-line shall follow.

Undo/ <Endpoint of line>: (P2) 

Angle << 100g =1>>: (P3) 

This option controls the baseline angle of which the give-way-line markings will follow. Input can be done using keyboard values or by picking the angle from the drawing. When picking from the drawing, a rubber band will appear from the base point (P2) and the angle is applied by picking a third point (P3) defining the angle.

Using 3 points:

Using polyline:

The angle from P2 to P3 is used for aligning the give-way-line symbols.

Note:  All SNAP functions in CAD can be utilized for accurate positioning.